[Instructor Guide] Forklift

© ALL RIGHTS RESERVED

Exercise 1: Movements• Create a program in the Scratch 1.4 software to allow the Forklift to lift a load.• Start the program by clicking on the green flag found at the top right hand corner of the Scratch 1.4 software. Any unauthorized reprint or use of this material is prohibited.

Exercise 2: Distance Sensor• Modify your program to the one shown below.• In this program, the Forklift will keep lifting a load until the distance sensor detects a value of 20 followed by dropping it.• Try changing the distance sensor value. Any unauthorized reprint or use of this material is prohibited.

Exercise 3: Tilt Sensor (Remote Control)• Create a program to control the Forklift using a tilt sensor.• In this program, the tilt sensor value of 1 and 3 controls the motor turning direction. While, the tilt sensor value of 2 and 4 controls the motor power. Any unauthorized reprint or use of this material is prohibited.